How to Replace the Serpentine Belt on Many General Motors Products

It would be of course terrifying for you to replace a serpentine belt on your Chevy Cavalier or Pontiac Sun fire as it cost a lot. But as you need it you have find its replacement at any cost. Mostly car shops charge hundreds of dollars for this task. If you can do it on your own then why are you going to waste your huge amount of money? It is not too difficult job but all you must know is how to replace the serpentine belt on many general motors products. Lets us see the steps and procedure required for this task.

Things you’ll need:

You may probably require:

• A new serpentine belt (you can get it on 20 dollars with shipping included)
• A 15 MM wrench (used to turn the tensioner)

Step 1:

First of all, you require backing off the tensioner. You can do this by rotating the 15 MM nut on the center of the tensioner in clockwise direction on the majority of car models. On numerous models, 15 MM nut is right beside the inner fender. A number of car owners mill the wrench end of their box wrench thus they could fit a nice snug pipe over the wrench and it works well at all. You can also use this if it works for your car as well. You may also ground flats on the socket and was able to make use of a large pair of vice grips to grasp the socket. It does provide better results too.

Step 2:

To remove the serpentine belt, release the tension off of the belt. Keep release the tensioner slowly at this time.

Step 3:

Now finish taking out the old belt.

Step 4:

Next put the new belt on starting with the lower pulleys typically the crank will be the mainly difficult in this case. A long handled screwdriver can help you a lot.

Step 5:

Now if you have done with putting the belt on all pulleys except for the alternator, at this time you are going to have to restore the tensioner once more. Your companion can help you at this moment while rotating tensioner another time and slipping the belt over the alternator pulley.

Step 6:

Next release the tensioner gradually.

Step 7:

Now make it certain that the belt is properly set over all of the pulleys and is correctly tensioned as well.

Step 8:

After that start your car to check if the belt is working properly.

Tips & Warnings:

If you adopt the same way as discussed above to replace the serpentine belt of your car you can not only save your cash but also can take away yourself from any sort of risks and hazards